Bosch Dishwasher Error Code F69

F69 indicates that the circulation pump pressure level switch contacts are signaling a blockage in the pump system. The dishwasher has detected that water is not circulating at the expected pressure through the wash circuit. The control board stops the cycle to prevent damage to the pump or other components. Diagnosis involves checking the heater relay, heater pressure switch, and the circulation pump itself.

No, you should not continue running the dishwasher while the F69 code is active. The error indicates the pump is not circulating water properly, and running the machine in this condition can cause the pump motor to overheat or sustain additional damage. Address the underlying cause before resuming normal use.

A reset may temporarily clear the F69 code from the display, but the error will return if the underlying problem has not been resolved. The control board will detect the same pressure switch fault or blockage condition as soon as the pump is asked to run again. Resetting without repairing is not a solution and could allow repeated stress on the pump motor.

Some causes of F69 are DIY-friendly, particularly clearing physical blockages from the sump filter and pump area. Removing the filter basket and inspecting the sump for debris is a good first step that requires no tools or parts. However, if the fault is caused by a failed pressure switch, heater relay, or pump motor, those repairs involve electrical components and may be better handled by a qualified technician.

Repair costs depend on which component has failed. Clearing a physical blockage yourself costs nothing beyond your time. Replacing a heater pressure switch or heater relay typically runs between $50 and $150 in parts, plus labor if a technician is involved. A full circulation pump replacement can cost between $150 and $400 or more depending on parts and labor rates in your area.