Bosch Dishwasher Error Code Motor won't run

This fault indicates that the wash pump motor is not starting or running during the cycle. On the WFL 2060 platform, it is signaled by flashing indicator lights during a diagnostic test. The most common causes are a short-circuited triac, a faulty speed control circuit, or a failed reversing relay, all of which are located on the control module. Without a functioning motor, the dishwasher cannot circulate water and will not clean dishes.

No, the dishwasher should not be used while this fault is present. Without the motor running, water will not circulate properly, and the appliance will not complete a wash cycle. Continuing to attempt cycles could also stress other components in the control circuit. Power to the unit should be disconnected until the fault is diagnosed and repaired.

A power reset may temporarily clear fault indicators, but it will not resolve the underlying hardware failure causing the motor not to run. If the triac is shorted, the relay has failed, or the speed control circuit is damaged, the fault will return as soon as the machine attempts to run the motor again. A proper repair addressing the failed component is required for a lasting fix.

Some basic checks, such as inspecting motor connector wiring for damage or corrosion, can be done by a knowledgeable DIYer. However, diagnosing and replacing a faulty triac, speed control circuit, or reversing relay typically requires electronic testing skills and safe handling of control board components. If the control module needs replacement, a qualified appliance technician is strongly recommended.

Repair costs vary depending on the specific failed component. If only a relay or a wiring connection is at fault, costs may be relatively modest, typically in the range of $75 to $200 including labor. If the full control module requires replacement, costs can range from $200 to $450 or more depending on the part price and local labor rates.