Bosch Dishwasher Error Code S3

S3 is a status code specific to Bosch dishwashers equipped with the Apexx SH_99 full text display. It means the control system ran a diagnostic check and found no faults or errors in any monitored system. It is not an error code and does not indicate a problem. No repair or service action is required when S3 is displayed.

Yes, it is completely safe to operate your dishwasher when S3 is displayed. The code confirms that no faults were detected, meaning the machine is cleared for normal use. There are no unsafe conditions associated with this status readout.

There is no repair cost associated with the S3 code because it indicates no fault is present. If a technician was called and S3 is the only code found, you may still be charged a standard diagnostic or service call fee, which typically ranges from $75 to $150 depending on your location and the service provider.

No fix is needed for the S3 code. It is a no-fault status indicator, meaning the dishwasher's self-diagnostic system found everything operating correctly. If you are seeing S3 but your dishwasher is still performing poorly, the underlying issue may be intermittent and should be diagnosed through hands-on functional testing.

The S3 code does not need to be cleared because it is not a fault. It is a normal diagnostic status message. If S3 appears after a reset, that simply means the reset completed successfully and the machine found no errors during its post-reset self-check.