Electrolux Refrigerator Error Code LJ

The LJ code on an Electrolux refrigerator, specifically DF80 and DF80X models, indicates that the unit is in Show Room mode. In this mode, the control panel and interior lighting operate normally but the refrigeration system is completely shut off. The refrigerator will not cool food while this code is active. Unplugging the unit from the outlet is the first step to exit this mode.

No. When the LJ code is active, the compressor and refrigeration system are completely inactive and the unit is not producing any cooling. Food stored inside will not be kept at a safe temperature and may spoil quickly. Do not store perishable food in the refrigerator until the LJ code is cleared and the unit has returned to normal cooling operation.

In most cases, there is no repair cost at all, since exiting Show Room mode simply requires unplugging and replugging the unit. If the mode keeps returning due to a faulty control panel, panel replacement parts and labor can typically range from around 150 to 400 dollars depending on your location and service provider. A control board replacement, if needed, can cost more and would require a technician to diagnose.

Unplug the refrigerator from the wall outlet and leave it disconnected for at least one minute before plugging it back in. This power cycle should exit Show Room mode and allow the refrigeration system to resume normal operation. If the LJ code returns after the unit is powered back on, check the control panel for any stuck or continuously pressed buttons, as these may be re-triggering the mode.

Yes, unplugging the unit from the outlet is the prescribed method to exit Show Room mode and clear the LJ code. After plugging the refrigerator back in, the refrigeration system should start up and begin cooling normally. If the code reappears, the control panel or main control board may need further inspection.