Electrolux Refrigerator Error Code rA

The rA code on Electrolux DFI80 and DI80X refrigerators means the ice maker sensor detected no temperature change within 8 minutes of a water refill attempt, indicating that no water reached the ice maker. This is most commonly caused by an empty internal water reservoir. Refilling the reservoir and pressing the Ice Maker button will typically clear the alert.

A simple power reset alone is unlikely to permanently clear the rA code because the alert will reappear the next time the ice maker attempts a fill cycle and again detects no water. The correct way to clear the code is to address the root cause, typically by refilling the reservoir, and then pressing the Ice Maker button to trigger a new fill attempt. If water is successfully detected, the alert will clear on its own.

In most cases there is no repair cost at all, since the fix is simply refilling the water reservoir. If the issue is a clogged water filter, replacement filters typically cost between $15 and $50 depending on the model. If the ice maker temperature sensor turns out to be faulty, parts and labor for that repair could range from $100 to $250 or more, though this is an uncommon cause of the rA code.

Start by refilling the internal water reservoir with fresh water. Allow a few minutes for the water to pass through the filter and prime the fill path, then press the Ice Maker button to restart the cycle. If the code returns, check whether the water filter is clogged and needs replacement, and verify there are no obstructions in the water line between the reservoir and the ice maker.

The rA alert is not a safety hazard. It is a protective notification that prevents the ice maker from repeatedly cycling without water, which could cause unnecessary wear. The refrigerator will continue to cool and operate normally while this alert is active. Addressing the water supply to the ice maker is straightforward and does not require urgent service.