Frigidaire Oven Error Code End

End means a timed cooking or self-cleaning cycle has finished and the oven has automatically shut itself off. It is a normal status notification, not a fault or error. The oven's electronic control board triggers this message when the programmed cycle duration reaches zero. Press Clear/Off to silence the beeping and dismiss the display.

The oven has already shut off automatically when End appears, so there is no active heating hazard. However, if the oven completed a self-clean cycle, the interior and door will still be very hot for some time afterward. It is best to press Clear/Off promptly and allow the oven to cool before opening the door after a cleaning cycle.

Under normal circumstances, the End message requires no repair and no parts, so the cost is zero. If the End message appears without any timed cycle having been set, or if the display will not clear after pressing Clear/Off, that could point to a control board issue worth investigating. A service call for control board diagnosis typically runs in the range of $75 to $150 for labor, with board replacement parts ranging from $100 to $300 or more depending on the model.

Press the Clear/Off button on the control panel to clear the End message and stop the beeping. This signals the control board to reset the display to standby mode. No further steps are needed, and the oven is ready for normal use immediately after.

Yes, pressing Clear/Off clears the End notification and returns the oven to normal standby mode. It does not affect any stored clock settings or other programmed preferences. After pressing the button, you can immediately begin a new cooking cycle if needed.