Frigidaire Range Error Code E

The flashing E on a Frigidaire range is a surface control error indicator. It appears at power-up or after a power failure when a surface burner was left in the ON position, when cookware has boiled dry, or when water, oil, or food is on the control panel. It is a safety feature that prevents the range from resuming normal operation until all burners are confirmed to be off.

The E code itself is a built-in safety response, not a sign that something has already gone wrong mechanically. However, the conditions that trigger it, such as burners left on during a power outage or a boil-dry event, do represent situations that require your attention. Address the underlying condition promptly and verify all burners are off before clearing the code.

If the issue is a faulty surface element switch, repair costs typically range from around $75 to $200 including parts and labor, depending on your location and service provider. A control board replacement is more involved and can range from $150 to $400 or more. A diagnostic service call to identify the root cause usually runs between $50 and $100, which is often applied toward the total repair cost.

In most cases, yes. Turn all four surface burner controls to the OFF position and then reset the clock to the correct time of day. This confirms to the control system that the range is in a safe state and should clear the flashing E. If the code continues to appear after this reset, further diagnosis is needed.

Many instances of this code can be resolved without professional help by turning all surface controls to OFF, cleaning any spills from the control panel, and resetting the clock. If the code persists after these steps, the cause may be a defective surface element switch or control board, which typically requires a technician to diagnose and repair.