mypros+
Model reference

Frigidaire 766

Dishwasher

8 documents55 error codes5 service modes

Available documentation

Service Manual

  • Service Data Sheet2 pg
    Covers this model
  • Technical Service Manual 2005 Dishwashers Precision Select Electronic Control Models36 pg
    Covers this model

Wiring Diagram

  • Wiring Diagram1 pg
    Covers this model
  • Wiring Diagram2 pg
    Covers this model

Tech Data Sheet

  • Tech Data Sheet13 pg
    Covers this model
  • Tech Data Sheet2 pg
    Covers this model

Other

  • 599567326512 pg
    Covers this model
  • 599572379714 pg
    Covers this model
MyPros+ Max

Diagnose your Frigidaire 766.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (55)

CodeMeaning
ASA sensor has failed.C3The oven door is not fully closed, preventing the pyrolytic cleaning function…CLOOven door is open during self-clean cycleCSCondenser thermostat sensor has failed (heat pump models only); displays for 1…EOven control has detected a fault or error condition (any E code displayed on…ERRORSensor did not detect steam properly during sensor cooking or reheating; steam…ESA sensor has failed.FOven control has detected a fault or error condition (any F code displayed on…F01Touch panel failure.F02Touch panel failure.F03The oven user interface board is incorrectly configured.F04Touch panel failure.F05Touch panel failure.F10Oven temperature runawayF102The oven door is not fully closed or the door lock is defective.F11Stuck keyF12Keyboard configuration alarmF13Data written to non-volatile memory has failed verification.F14Oven control system has detected a fault or anomaly.F15Keyboard error.F17The oven user interface board is unable to configure the touch panel.F18Oven relay board failure (wiggler).F19The oven user interface board is unable to configure the oven relay board.F20Communication failure between EOC and ESEC system.F22Communication failure between the oven user interface board and the oven relay…F23Communication failure between the oven user interface board and the glass touch…F25The communication between the oven user interface and the oven relay board…F27The communication between the oven user interface and the oven relay board…F28The communication between the oven user interface and the touch panel cannot be…F29The communication between the oven user interface and the touch panel cannot be…
View all 55 error codes
F30Open oven temperature sensor (RTD).F31Shorted oven temperature probe (RTD).F33Meat probe temperature sensor shorted or too hot.F40Cooktop Lockout error.F45Cooling fan speed too low.F46Cooling fan speed too high.F50A/D Out of RangeF90Motor Door Lock mechanism failureF91Maximum oven door unlock attempts exceeded.F92Maximum oven door open time exceeded.F93Maximum oven door lock time exceeded.F94Maximum oven door lock attempts exceeded.F95Motor Door Lock mechanism failureF96The oven door has been detected open during a Self Clean cycle.HOTMeat probe temperature has exceeded the maximum allowable temperature.HSA sensor has failed.LEDs 3+7Problem with the communication link between the oven control board and the…LEDs 4+5Oven control not properly calibrated at the factory.LEDs 4+5+6Door motor mechanism failure.LEDs 4+6Control has sensed a potential runaway oven condition; control may have shorted…LEDs 4+7Open RTD sensor probe / wiring problem.LEDs 5+7Incorrect Micro ID, controller self check failed.LEDs 6+7Incorrect EEPROM Checksum, control internal checksum may have been corrupted.OSOutdoor ambient thermostat sensor has failed (heat pump models only); displays…SFSabbath Failure

Service modes (5)

  • Demonstration Mode["Touch SET CLOCK","Touch the number 0","Touch and hold START for three seconds","DEMO ON will…
  • Oven Calibration / Temperature Adjustment["Set EOC to bake at 550°F.","Within 5 seconds of setting 550°F, press and hold the bake pad for…
  • Oven Temperature Calibration Adjustment["Set EOC to bake at 550°F.","Within 5 seconds of setting 550°F, press and hold the bake pad for…
  • User Preference Menu (UPO / AUd / ES / rSt)["Ensure oven is in idle mode with no timers active.","Press and hold both the oven light icon and…
  • Water Service Test["Clear all cycles and ensure all lights are out on the console.","Turn the Cycle Selector to the…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Frigidaire dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax