Model reference

Frigidaire 787

Dishwasher

7 documents37 error codes16 service modes

Available documentation

Service Manual

  • Exploded View of Wash System - Service Documentation2 pg
    Covers this model
  • Dishwasher Use & Care Manual22 pg
    Covers this model
  • All about the Use & Care of your Dishwasher20 pg
    Covers this model

Wiring Diagram

  • Wiring Diagram1 pg
    Covers this model

Service Flash

  • Service Flash DW0907 Latch Assembly Not Working Properly1 pg
    Covers this model

Installation Guide

  • Dishwasher Use & Care Guide28 pg
    Covers this model

Other

  • 160203000011551 pg
    Covers this model
MyPros+ Max

Diagnose your Frigidaire 787.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (37)

CodeMeaning
CEUI to Main Control Board communication error after a period in operation.CFCheck Food reminderCLClose dishwasher doord-ODoor open during steam clean cycle.EOven control has detected a fault or error condition (any E code displayed on…E0Wrong configuration of the induction module.E1Wrong configuration of the user interface.E3Over or under voltage condition detected.E4Over temperature at coil temperature sensor caused by heating an empty pan at…E6Defective induction module.E7Fan defect.E8Communication/wiring between induction generator and user interface interruptedE9User interface touch system defect.EFEvaporator Fan Failure.ERREURSensor did not correctly detect steam emission during sensor cooking (microwave)FOven control has detected a fault or error condition (any F code displayed on…F10Control has sensed a potential runaway oven condition; control may have a…F11Shorted key detectedF13Control's internal checksum may have become corrupted.F14Relay watchdog failure.F15Controller self check failed.F20Bad communication between display board and relay board.F23The controller failed to communicate with the upper convection fan and oven…F24The controller failed to communicate with the lower convection fan and oven…F25No zero cross signal detected on the upper or lower convection fan and oven…F26Missing lower oven select signal on the lower oven convection fan and oven…F30Open RTD sensor probe or wiring problemF31Shorted RTD sensor probe or wiring problemF32Key loop is detected as an open circuit.F90Door motor mechanism failure.
View all 37 error codes

Service modes (16)

  • ADC Defrost Initiation/TerminationDepress the fresh food light switch 5 times in 6 seconds (light bulb must be working) to initiate…
  • Child Lock Controls["Touch and hold the NO HEAT DRY pad for 3 seconds.","The CONTROLS light will come on, indicating…
  • Demo mode deactivation["Enter Menu mode, and a code will appear in the timer display.","Touch the Timer key to cycle…
  • Display / Showroom ModePress FF UP and FF DOWN simultaneously for up to 10 seconds.
  • Error mode["Enter Menu mode, and a code will appear in the timer display.","Touch the Timer key to cycle…
  • Fresh Food Ice Maker (FFIM) Diagnostic ModePress FZ UP and FZ DOWN temperature pads for up to 10 seconds simultaneously
  • Ice Maker Test CyclingRemove cover by inserting screwdriver in notch at bottom and prying cover from housing
  • Ice Maker Test Cycling (mechanical ice maker)Remove cover by inserting screwdriver in notch at bottom and prying cover from housing
  • Ice Maker Test Cycling (momentary contact switch type - 240389016/240389618)Press the momentary contact on the ON/OFF switch for approximately 15 seconds
  • Manual Defrost Initiation (Counter Depth Side-by-Side with ADC - 241532603)Press and hold the Freezer temperature UP (WARMER) key while pressing the Fresh Food temperature…
  • Manual Defrost Initiation (Top Mount models with Electronic Defrost Control)Depress the fresh food light switch 5 times in 6 seconds (light bulb must be working).
  • Menu mode["Touch and hold the Main Power key
  • Oven temperature calibration1
  • Sabbath ModePress FZ DOWN and FF UP simultaneously for up to 10 seconds.
  • Service mode["Enter Menu mode, and a code will appear in the timer display.","Touch the Timer key to cycle…
  • System Diagnostic ModePress FZ UP and FZ DOWN temperature pads simultaneously for up to 10 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax