Frigidaire Dishwasher Error Code CE

The CE code on a Frigidaire dishwasher indicates a general malfunction or fault condition detected by the appliance's control system. It is a broad error that signals something has gone wrong beyond the dishwasher's ability to self-correct. Because it is not tied to a single specific component, Frigidaire recommends contacting their Customer Care Center at 1-800-944-9044 for guided troubleshooting or to arrange service.

It is not advisable to continue operating the dishwasher while the CE code is active. The code indicates the control system has detected an abnormal condition, and running the appliance in this state could worsen an existing electrical or component issue. Discontinue use and contact Frigidaire Customer Care at 1-800-944-9044 before running additional cycles.

Repair costs for a CE error vary widely depending on the root cause. A wiring or connection fix may fall in the range of $75 to $150 for a service call and labor, while a control board replacement can cost anywhere from $150 to $350 or more including parts and labor. Getting a diagnostic evaluation from an authorized technician is the best way to get an accurate estimate for your specific situation.

In some cases, cutting power to the dishwasher at the circuit breaker for several minutes and then restoring it may clear a temporary fault. However, if the CE code returns after a reset, the underlying cause likely requires professional diagnosis. Frigidaire specifically directs customers to their support line or an authorized technician for this error, as it may involve the control board or internal wiring that is not safely serviced without proper tools and training.

A power reset, performed by switching off the circuit breaker for a few minutes and restoring power, may temporarily clear the CE code if the fault was caused by a momentary power irregularity or software glitch. However, if the fault condition that triggered the code has not been resolved, the CE error will typically return. A reset alone should not be considered a repair.