Frigidaire Dishwasher Error Code E:08

The E:08 code means the heat pump has detected a low water level inside the dishwasher tub. To protect the heat pump from running without sufficient water, the appliance disables heating and continues the cycle without it. The issue can stem from restricted water supply, leaks, or items in the rack collecting water. Correcting the water level condition will clear the fault.

Running the dishwasher with E:08 active is not recommended for extended periods. The heating function is disabled as a protective measure, so dishes will not be sanitized or dried properly. More importantly, if a leak is causing the low water level, continued operation could cause water damage to your flooring or cabinetry. It is best to diagnose and resolve the cause before running additional cycles.

If the fix involves only adjusting the water supply valve or repositioning items in the rack, there is no parts cost involved. Replacing a door gasket typically runs in the range of $20 to $60 for the part, plus labor if a technician is needed. An inlet water valve replacement generally costs between $25 and $80 for the part. Professional diagnostic and repair service visits can add $75 to $150 or more depending on your location and the complexity of the repair.

Start by checking that the water supply valve under the sink is fully open and that the inlet hose has no kinks or bends. Reposition any bowls or pots in the lower rack so they face downward rather than collecting water. If those steps do not resolve the issue, inspect the door gasket for damage and look for signs of leakage beneath the unit. A persistent code after these checks may point to a faulty inlet valve or water level sensor that needs testing or replacement.

A reset may temporarily clear the E:08 code, but the error will return if the underlying cause is not fixed. You can attempt a reset by canceling the current cycle or cutting power to the unit for a few minutes. However, if the water supply issue, leak, or component fault still exists, the heat pump will detect the low level again and reactivate the code. A reset alone is not a repair.