Frigidaire Dishwasher Error Code E:02

E:02 indicates a faulty heater relay on the power module, which is the main control and power board located in the base of the dishwasher. The heater relay is responsible for switching electrical current to the heating element during wash and dry cycles. When this relay fails, the dishwasher detects the fault and displays E:02. Resolving this error requires replacing the power module.

A simple reset is unlikely to permanently clear E:02 because the code reflects an actual hardware fault with the heater relay on the power module board. The error may temporarily disappear after a reset but will return once the dishwasher attempts to activate the heater circuit again. The underlying component failure must be addressed by replacing the power module.

The cost to repair E:02 depends on whether you hire a technician or do the repair yourself. A replacement power module part typically costs in the range of $80 to $200 depending on the specific model. If you hire a professional, labor costs can add another $100 to $200 on top of the part, bringing the total repair estimate to roughly $180 to $400.

A knowledgeable DIYer can replace the power module in the base of the dishwasher, but the repair does involve working with high-voltage components. You should disconnect power to the appliance at the breaker before beginning any work. If you are not comfortable working around electrical components, a qualified technician should perform the replacement.

You should not continue using the dishwasher while E:02 is active. A faulty heater relay can mean the heater is not being controlled properly, which poses a risk of the heater circuit behaving unpredictably. Discontinue use until the power module has been inspected and replaced.