Frigidaire Dishwasher Error Code E:00

E:00 means no error codes are stored in the dishwasher's control board memory. It appears when diagnostic mode is accessed and the fault log is empty. This is a status confirmation, not a fault code, and does not indicate any problem with the appliance.

Yes, it is completely safe to use the dishwasher when E:00 is displayed. The code confirms there are no stored faults in memory. The appliance can be returned to normal use immediately.

There is no repair cost associated with E:00 since it is not a fault code. If the dishwasher has an unrelated performance issue that prompted you to investigate, repair costs will depend on the actual fault identified. Diagnostic service calls from a technician typically range from $75 to $150, with additional costs based on the specific repair required.

No fix is needed for E:00 since it is not an error. If the dishwasher is otherwise working normally, simply exit diagnostic mode by pressing the appropriate button sequence or cycling power. If the unit has a performance issue that led you to check for codes, run a full wash cycle and re-enter diagnostic mode to see if a new fault code appears.

E:00 does not need to be cleared because it is not a fault. Exiting diagnostic mode or cycling power will return the display to its normal state. A reset may also erase any previously stored fault codes, which is why it is good practice to check for codes before performing a reset if you are investigating a problem.