Frigidaire Dishwasher Error Code E:06

E:06 means the dishwasher's power module is not detecting a signal from the door latch Hall sensor. The Hall sensor monitors whether the door latch is properly engaged, and without that confirmation signal, the dishwasher will not run. The Clean LED flashing alongside this code is the control system's indicator for this specific fault. The issue can stem from latch misalignment, wiring problems, a failed sensor, or a faulty power module.

No, the dishwasher will not operate while E:06 is active, which is by design. The control system prevents the wash cycle from starting when the door latch signal is absent to avoid running with an unsecured door. You should resolve the fault before attempting to use the appliance.

A reset may temporarily clear the error display, but the code will return immediately or on the next start attempt if the underlying fault has not been corrected. The Hall sensor must actually detect the door latch signal for the error to clear permanently. Address the alignment, wiring, or component issue first, and the code should not reappear after a reset.

In many cases, yes. Start by opening and firmly closing the door, then inspect the door latch to confirm it is properly aligned above the Hall sensor on the inner door panel. If the latch appears off-center or shifted, carefully reposition it and test the machine. You can also check the wiring connections between door switch Q2 and the power module for loose or disconnected terminals using a multimeter to verify continuity.

Repair costs vary widely depending on the root cause. If the fix is simply realigning the door latch or reseating a loose connector, there may be no parts cost at all and only minimal labor if you handle it yourself. Replacing the Hall sensor or wiring harness typically runs in the range of $30 to $100 for parts. A power module replacement is more expensive, generally ranging from $80 to $200 or more for the part alone, plus any applicable labor costs.