Frigidaire Range Error Code F02

F02 on a Frigidaire range indicates a Touch Panel Failure, meaning the User Interface board has been detected as defective or is not communicating correctly with the range's control system. This code appears when the oven cannot reliably process input from the touch panel. The result is that the range may be unresponsive to keypad commands until the issue is resolved.

A homeowner comfortable with basic appliance work can attempt the first diagnostic steps: performing a power reset and checking that all wire harness connectors at the control panel are firmly seated. If those steps do not resolve the code, replacing the User Interface board typically requires disassembling the control panel area and is best handled by someone with experience working on appliance electronics. Always disconnect power before accessing internal components.

If the fix is simply reseating a loose connector, there is no parts cost involved. If the User Interface board requires replacement, parts alone typically range from around $50 to $200 depending on the specific model, with additional labor costs if a technician performs the repair. Getting a repair estimate before ordering parts is advisable to compare it against the cost of replacement.

A power reset will clear F02 if the fault was caused by a transient electrical issue. Disconnect the range from its power supply, wait at least 30 seconds, and restore power. If the code returns after the reset, a hardware problem such as a loose connector or a failed UI board is the likely cause and will need to be physically addressed.

An F02 code means the touch panel or UI board is not functioning reliably, so the range may not respond correctly to commands. Using the appliance in this condition is not recommended because you may not be able to control the oven or cooktop as intended. It is best to resolve the fault before relying on the range for normal cooking.