Frigidaire Range Error Code F025

F025 means the oven user interface board and the oven relay board cannot establish communication with each other. These two boards must exchange data for the oven to operate correctly. The fault prevents the range from running to avoid unsafe behavior. It can be caused by a wiring issue, a loose connector, or a failed control board.

No, you should not attempt to use the oven while this code is active. The F025 fault means the control system cannot properly coordinate between the user interface and the relay board, which controls the heating elements. Operating the appliance in this state could lead to unpredictable behavior. Resolve the fault before resuming use.

Repair costs vary depending on the root cause. If a power reset resolves the issue, there is no parts cost. Wiring harness or connector repairs are generally lower cost, typically in the range of $50 to $150 in parts. Replacing a user interface board or relay board can cost between $100 and $300 or more for parts alone, plus labor if a technician performs the repair.

Disconnecting power to the range for 30 seconds and then restoring it is the first recommended step and can clear the code if the fault was caused by a temporary glitch or power fluctuation. If the code returns after the reset, a deeper issue with the wiring or one of the control boards is likely present and will require hands-on diagnosis.

Start by disconnecting power for 30 seconds and reapplying it. If the code clears, monitor the range for recurring faults. If it returns, inspect the wiring harness and connectors between the user interface board and the relay board for damage, corrosion, or loose pins. If the wiring is intact, one or both control boards may need to be replaced, which typically requires a technician.