Frigidaire Range Error Code F096

F096 means the control board detected that the oven door was open or not fully locked during a self-clean cycle. The range monitors the door switch continuously during self-clean because of the extreme temperatures involved. When the switch does not confirm a closed and locked door, F096 is triggered and the cycle may be interrupted. Checking that the door closes fully and the lock mechanism engages completely is the first step.

Normal cooking functions on the range are generally unaffected by F096 since the error is specific to the self-clean cycle and door lock system. However, you should not attempt another self-clean cycle until the door closes and locks properly, as running a self-clean with a compromised door seal or lock is a safety risk due to the high temperatures involved.

Repair costs vary depending on the cause. If only a door adjustment or cleaning is needed, there may be no parts cost. Replacing a door switch typically costs between $15 and $50 for the part, while a door lock motor assembly can range from $30 to $100 or more. Adding a service call and labor, total repair costs generally fall between $100 and $250 depending on your location and the parts required.

In many cases, this error can be resolved without a technician. Start by checking that nothing is obstructing the door, that the hinges are intact, and that the door lock moves freely to the fully latched position. If the door switch or lock motor has failed, those parts can often be replaced by a confident DIYer, though a technician may be needed if the diagnosis or repair is unclear.

Resetting the range by cutting power at the circuit breaker for a few minutes may clear the code temporarily, but the error will return if the underlying cause is not corrected. If the door does not close and lock fully, or if the door switch or lock motor is faulty, the code will reappear the next time a self-clean cycle is attempted.