Gaggenau Range Error Codes

13 error codes for Gaggenau range models. Each links to the full diagnostic procedure from the service manual.

CodeDescription

F1Sensor sub-step fault code: indicator is interrupted (open circuit)F10Fault of inner oven sensor PT 1000 F11Fault of inner oven sensor PT 1000 F12Fault of core temperature sensor F13Fault of core temperature sensor / short circuit F14Fault of NTC-sensor / electronics F15Fault of NTC-sensor / electronics F2Sensor sub-step fault code: temperature is too high (short circuit)F3Sensor sub-step fault code: short circuit at indicator (open circuit)F30EEPROM not chooseable F4Sensor sub-step fault code: temperature is too low (short circuit)F40Locking mechanism information not available F42Door contact switch fault

MyPros+ Max

Get the full diagnostic procedure for any Gaggenau range error code.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts
Verified part numbers when replacement is required

Get started

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Gaggenau Range

F1 on my Gaggenau Range

M+

Sensor sub-step fault code: indicator is

From Service Manual 146127, p.19:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at the test points. Expected: 12 VDC and 5 VDC; a drop below 4.75 VDC on the logic rail points to a failed onboard regulator.

3.Inspect all connectors on the main control for corrosion, thermal stress, or backed-out pins. Reseat each connector with the power disconnected.

Part 00705047

Control module

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get started