Error code reference
GE Café Refrigerator Error Code 0604
Ice maker no water supply detected.
Ice maker no water supply detected.
MyPros+ Max
Get the full diagnostic procedure for 0604.
- ✓Step-by-step tests with expected resistance, voltage, and continuity values
- ✓Wiring diagram references and connector pinouts from the OEM service manual
- ✓Verified part numbers when replacement is required
Get the full procedure→
$29/month · Cancel anytime · Or $9.95 3-day pass
M+
M+ Max·GE Café Refrigerator
0604 on my GE Café Refrigerator
M+
Ice maker no water supply detected
From Service Manual 897165, p.17:
1.Access service mode to confirm the active fault code and read stored error history.
2.Measure the inlet valve coil resistance at the valve connector. Expected: 1,000 to 1,200 ohms per coil at room temperature.
3.Verify static water supply pressure at the inlet hose. Below 20 psi or fluctuating supply commonly triggers fill-timeout faults.
Part WPW10212598
Water inlet valve
Related GE Café refrigerator codes
All GE Café refrigerator codes →- 0001Refrigerator (FF) thermistor reading out of range.
- 0003Freezer (FZ) thermistor reading out of range.
- 0004Freezer (FZ) evaporator thermistor reading out of range.
- 0006Refrigerator (FF) evaporator thermistor reading out of…
- 0008Ambient temperature reading out of range.
- 0009Humidity sensor reading out of range.
- 0010Ice maker mold body thermistor reading out of range.
- 0100Freezer (FZ) fan feedback missing when fan is running.
View all 71 GE Café refrigerator codes
- 0101Freezer (FZ) fan feedback present when fan is off.
- 0102Freezer (FZ) fan cannot reach target RPM.
- 0103Condenser fan feedback missing when fan is running.
- 0104Condenser fan feedback present when fan is off.
- 0105Condenser fan cannot reach target RPM.
- 0106Refrigerator (FF) fan feedback missing when fan is running.
- 0107Refrigerator (FF) fan feedback present when fan is off.
- 0108Refrigerator (FF) fan cannot reach target RPM.
- 0109Ice box fan feedback missing when fan is running.
- 0110Ice box fan feedback present when fan is off.
- 0111Ice box fan cannot reach target RPM.
- 0200Freezer defrost heater on for max time.
- 0201Refrigerator defrost heater on for max time.
- 0202Five consecutive freezer abnormal defrosts.
- 0203Five consecutive refrigerator abnormal defrosts.
- 0300Excessive compressor run time.
- 0301Cooling system was on and the compressor remained off for…
- 0303Refrigerator temperature exceeded (setpoint + 20°F).
- 0304Freezer temperature exceeded (setpoint + 20°F).
- 03083-way valve lost.
- 0311Convertible drawer damper stuck closed.
- 0312Convertible drawer damper stuck open.
- 0313Convertible drawer temperature exceeded (setpoint + 20°F).
- 0314Convertible drawer freezing when set to warm.
- 03153-way valve cooling not detected in refrigerator evaporator.
- 03163-way valve cooling not detected in freezer evaporator.
- 0400DC voltage out of range.
- 0403Main control board software fault (replace board).
- 0404Main control board hardware fault (replace board).
- 0501Flow meter signal missing.
- 0502Flow meter pulsing with no water dispense.
- 0503Ice/water stops dispensing based on time (7-minute time…
- 0507Paddle switch input missing when main board has received a…
- 0508Paddle switch input present when main board has not…
- 0511Ice mold temperature invalid.
- 0512Ice box thermistor temperature invalid.
- 0515Door board relay driver is shorted (replace door board).
- 0601Ice maker harvest > 10-minutes.
- 06023 out of last 10 ice maker harvests were > 10-minutes.
- 0603Ice maker harvest not complete after 30-minutes.
- 0605Ice maker continues to sense a full bucket after an ice…
- 0700Stuck keys on dispenser board.
- 0713A refrigerator door opens for 15 minutes without being…
- 0714A refrigerator door opens for 60 minutes in the last…
- 0715100 left door openings in the last 24-hours.
- 0716100 right door openings in the last 24-hours.
- 0717Freezer drawer open for 15 minutes continuously.
- 0718Freezer drawer open for 60 total minutes in the last…
- 0719100 freezer drawer openings in the last 24-hours.
- 0721AutoFill sensors detect an object present over several…
- 0722AutoFill initialization failed.
- 0723Capacitive touch controlled reset.
- 0726Convertible drawer opens for 15-minutes without closing.
- 0727Convertible drawer opens for 60-minutes in the last…
- 0728100 convertible drawer openings in the last 24-hours.
- 0729Stuck keys on convertible drawer board.
- 0731Convertible drawer board communication error.
- 0732Door board communication error.
- 0733Dispenser board communication error.
- 0737AutoFill termination by no water level change.
- 0738AutoFill terminated by keypad before fill completed.
- 0739AutoFill terminated by target removal before fill completed.
- 0740AutoFill terminated by EMI noise.
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started →$29/month · Cancel anytime · Or $9.95 3-day pass