GE Oven Error Code F1-E2

F1-E2 on a GE oven indicates an electronic control malfunction, specifically a fault detected within the control board's own internal circuitry. The control board has run a self-diagnostic check and found an error it cannot recover from on its own. This code points directly to the control board as the failed component rather than an external sensor or wiring issue.

A GE oven displaying F1-E2 has a control board that is not functioning reliably, which means temperature regulation and safety monitoring may be compromised. It is not advisable to continue using the oven until the control board has been replaced. Operating the oven with a failed control board could result in unpredictable behavior such as incorrect temperatures or failure to shut off properly.

The cost to repair an F1-E2 error typically involves the price of a replacement control board plus labor if a technician is hired. Control board parts alone can range from roughly $150 to $400 or more depending on the specific oven model. Professional labor to diagnose and install the board can add another $100 to $200, bringing the total repair cost to anywhere from $250 to $600 or higher in some cases.

Disconnecting power to the oven and allowing a full reset is the recommended first step, and in some cases a temporary power issue may cause the code to clear. However, if the F1-E2 code returns after power is restored, the control board has a permanent internal fault and will need to be replaced. A reset alone is not a repair for a board that has genuinely failed.

The repair process starts by disconnecting power to the oven, either at the breaker or by unplugging it. After restoring power, if the F1-E2 code returns, the control board must be replaced. This is the only field-serviceable repair for this fault, as the board's internal components cannot be repaired individually.