GE Oven Error Code F1-E5

F1-E5 on a GE oven indicates an internal electronic control malfunction. The F1 code group points to the electronic range control board, and the E5 sub-code identifies a specific internal failure within that board. This fault means the control board itself has failed and cannot operate normally. The recommended fix is to disconnect power and replace the control board.

It is not recommended to continue using the oven while the F1-E5 code is active. A failed control board can produce unpredictable behavior, including improper temperature regulation or failure to shut off heating elements correctly. Discontinue use until the control board has been replaced.

The cost depends primarily on the price of the replacement electronic control board and whether you hire a technician. Control boards for GE ovens generally range from around $150 to $400 or more depending on the model. If a professional technician performs the repair, labor costs will add to that range, typically bringing the total to somewhere between $250 and $600 or higher depending on your location and the specific oven model.

The repair for F1-E5 involves disconnecting power to the oven and replacing the electronic control board. This is a task that experienced DIYers can perform, as it typically involves removing a few screws and disconnecting wire harness connectors. However, working with oven wiring requires care, and if you are uncomfortable with the process, a qualified technician should handle the replacement.

Disconnecting power and restoring it may temporarily clear the code if the fault was caused by a transient memory error, but F1-E5 typically returns quickly if the control board has a genuine internal failure. If the code reappears after a power reset, the board requires replacement. A reset alone is not considered a repair for this fault.