GE Oven Error Code F10

F10 on a GE oven indicates a fault in the upper or single door latch switch circuit. The control board has detected a problem reading the latch position, either in the unlocked/bake state or the locked/self-clean state. This is a safety-related fault that typically prevents the oven from operating until the circuit is restored. The most common causes are a failed latch switch, damaged wiring, or a loose connector at the control board.

It is not recommended to use the oven while F10 is active. This code indicates the control board cannot confirm the door latch position, which is a safety-critical function, especially for self-cleaning cycles. Operating the oven in this condition could bypass intended safety interlocks. The fault should be diagnosed and repaired before resuming normal use.

Repair costs vary depending on the failed component. A door latch switch assembly typically costs between $30 and $80 for the part alone. If professional labor is involved, total repair costs including diagnosis and installation generally range from $100 to $250. A control board replacement, if needed, can push costs higher, typically into the $150 to $400 range for parts and labor combined.

A knowledgeable DIYer can diagnose and often fix this error by checking continuity at connector CN1 between pin 5 and pin 7 with the latch unlocked, and between pin 5 and pin 6 with the latch locked. If a broken wire or loose connector is the cause, the repair is straightforward. Replacing the door latch switch assembly is also a manageable repair, though working near the oven's wiring requires the appliance to be unplugged before starting any work.

Resetting the oven by cutting power at the breaker for a few minutes may temporarily clear the F10 code, but the error will return if the underlying circuit fault is not repaired. A reset is useful as a first step to confirm whether the fault is intermittent, but it does not address a failed switch, broken wire, or corroded connector. A proper continuity test at CN1 is needed to find the root cause.