GE Oven Error Code F102

F102 on a GE oven indicates a User Interface data failure caused by a CRC (Cyclic Redundancy Check) error. This is an electronic problem where the UI control board fails its internal data integrity check. It means the control panel board is likely corrupted or has experienced an internal electronic failure. Replacement of the User Interface board is the standard resolution.

A power reset may clear the F102 code if the fault was a temporary electronic glitch rather than a true hardware failure. To reset, cut power at the breaker for at least 5 minutes before restoring it. If the code returns after the reset, the User Interface board has a persistent fault and will need to be replaced.

If the repair requires a new User Interface board, the part itself typically costs anywhere from $75 to $250 or more depending on the oven model. If you hire a professional technician, total repair costs including labor generally range from $150 to $400. Performing the replacement yourself can reduce the cost significantly, with the expense limited mainly to the cost of the part.

You can start by performing a hard reset: turn off the oven's circuit breaker for 5 to 10 minutes, then restore power to see if the code clears. If the F102 returns, the User Interface board will need to be replaced. Replacing the UI board is a moderate-difficulty repair that involves disconnecting wiring harnesses and ribbon cables, and is manageable for someone comfortable working with appliance electronics.

An F102 error indicates the control panel electronics are not functioning reliably, which means the oven may not respond correctly to inputs or maintain accurate settings. It is not recommended to continue using the oven while this code is active, as the control panel failure could lead to unpredictable behavior. The issue should be diagnosed and resolved before resuming normal use.