GE Oven Error Code F4-E0

The F4-E0 code on a GE oven means the control board has detected a short in the meat probe circuit. The meat probe is the plug-in temperature sensor used to monitor food temperature during cooking. The error is triggered when the probe's resistance readings fall outside the expected range, indicating a fault in the probe itself or its connection to the oven.

The F4-E0 error is specific to the meat probe circuit and does not necessarily affect the core heating functions of the oven. If you remove the probe and the error clears, you can often continue using the oven normally without the probe feature. However, if the error persists or the oven behaves abnormally, discontinue use until the fault is resolved.

If only the meat probe needs replacement, repair costs are generally low, typically in the range of $20 to $60 for the part, plus any labor if a technician is involved. If the probe jack, wiring harness, or control board is involved, costs can rise to the $100 to $300 range depending on parts and labor rates in your area. Diagnosing the fault yourself before calling a technician can help narrow down which component actually needs replacement.

In many cases, yes. Start by disconnecting power to the oven, removing the meat probe, and testing its resistance with a multimeter. A working probe should read approximately 78 kilohms at 60 degrees F or 37 kilohms at 90 degrees F. If the probe tests out of range, replacing it is a straightforward repair. Also check that the connection between the probe jack and the rear harness is secure and free of corrosion.

Resetting the oven by disconnecting power may temporarily clear the code, but the error will return if the underlying fault is not corrected. If the meat probe is shorted or the jack connection is faulty, the control board will detect the problem again as soon as power is restored and the probe circuit is active. A permanent fix requires addressing the probe or connection issue.