GE Oven Error Code SENSOR ERROR

SENSOR ERROR on a GE oven means the oven's steam sensing system could not detect the expected moisture from your food during an automated cooking program. This typically happens when the selected program does not match the food type or quantity, or when steam is blocked by sealed plastic wrap, a tight lid, or a covered liquid. It is a setup or usage issue in most cases and does not indicate a broken component.

Yes, pressing the CLEAR/OFF pad will clear the error and reset the control. However, if you run the same program with the same setup, the error is likely to return. You need to also correct the underlying cause, such as venting the plastic wrap, loosening the lid, or selecting the correct cooking program, before restarting the cycle.

In most cases, there is no repair cost at all because SENSOR ERROR is caused by a cooking setup mismatch rather than a faulty component. Correcting the program selection or adjusting the food container costs nothing. If a technician visit is needed to rule out an actual sensor hardware issue, service call fees typically range from 75 to 150 dollars depending on your region, with additional parts and labor costs if a component does need replacement.

Press the CLEAR/OFF pad to reset the control and clear the error. Then check that the cooking program you selected matches the food you are preparing. If you are using plastic wrap, cut a small vent slit in it. If using a lid, make sure it is not sealing tightly, and if heating a liquid, leave it at least partially uncovered so steam can reach the oven sensor.

The SENSOR ERROR itself is not a safety hazard. It simply means the oven's cooking program could not complete as intended because it did not detect the expected steam level. The oven stops the automated cycle to prevent overcooking or improper results. Addressing the setup issue and restarting is all that is needed.