Kenmore Washer Error Code E22

E22 on a Kenmore washer means the machine detected a fill problem and could not bring water into the drum properly within the required time. The washer stops the cycle to prevent it from running without adequate water. This code points to the water supply system, including the inlet valve, supply hoses, and water level sensor.

No, you should not continue running the washer while E22 is active. The code indicates the machine cannot fill correctly, and running a wash cycle without proper water levels can damage the motor, pump, and drum components. Address the fill issue before resuming normal use.

Resetting the washer by unplugging it for a few minutes may temporarily clear the E22 code, but the error will return if the underlying fill problem has not been fixed. A reset is useful for ruling out a one-time electronic glitch, but a recurring E22 always points to a physical issue with the water supply, inlet valve, or sensor system that needs to be diagnosed and repaired.

Start by confirming that both the hot and cold manual water supply valves behind the washer are fully open. Next, turn off the water, disconnect the supply hoses, and check the inlet valve screens for clogs or mineral buildup. If the supply and screens are clear, test the water inlet valve solenoids and inspect the pressure sensor hose for cracks or disconnections. Replace any components that fail inspection.

Repair costs depend on the root cause. Cleaning clogged inlet valve screens costs nothing beyond your time. Replacing a water inlet valve typically runs between $20 and $80 for the part, plus labor if you hire a technician. A water level sensor replacement is generally in the $15 to $50 range for the part. Professional diagnosis and labor fees can add $75 to $150 or more depending on your area.