Kenmore Washer Error Code E60

E60 on a Kenmore washer indicates an internal problem detected within the main control board. The board has identified a fault in its own circuitry and stopped the machine to prevent further damage. This can be caused by a temporary glitch, a power surge, or a physical failure of the board itself.

The first step, a power reset, is something any homeowner can safely do. Beyond that, checking and reseating wiring harness connectors at the control board is a task some experienced DIYers can handle. However, if the control board itself has failed, replacing it requires comfort with appliance disassembly and working near electrical components, so many people prefer to hire a technician for that step.

If a reset clears the code, there is no cost beyond your time. If the main control board needs to be replaced, repair costs typically range from around $150 to $400 or more depending on the specific model and whether you use a professional technician or replace the part yourself. Getting a diagnosis from a technician first can help you decide whether repair or replacement of the appliance makes more sense.

A reset will clear E60 if the cause was a temporary logic glitch. Unplug the washer, wait at least 30 seconds, then plug it back in and restart. If the code returns after the reset, the problem is likely a persistent hardware fault that requires further diagnosis or a control board replacement.

The washer will typically stop operation when E60 is active, which prevents you from running a cycle. You should not attempt to bypass the error and force the machine to run, as the control board fault could cause unpredictable behavior. Address the fault before resuming normal use.