Error code reference

Kenmore Washer Error Code F/07

Motor Control Unit (MCU) error; the main control has detected a short in the MCU. If failure occurs during high-speed spin, door unlocks after 3 minutes.

SourceKenmore Appliance - Service Manual: Diagnostic Guide (11045091400)p. 3

Diagnostic procedure

The full F/07 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Unplug washer or disconnect power, then check wire harness connections between drive motor, MCU, and CCU.

SourceKenmore Appliance - Service Manual: Diagnostic Guide (11045091400)p. 3

More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock F/07 procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

5 manuals in the MyPros+ library document this code for Kenmore washer.

Models covered by the manuals that document this code

More models are covered than are listed here.

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax