Kenmore Washer Error Code F60

F60 on a Kenmore washer means the Central Control Unit has detected a heartbeat failure, specifically that it cannot communicate with the User Interface board. This communication link is required for the washer to accept input and operate cycles safely. The washer will stop and display the code until the fault is resolved. The problem is typically in the wiring harness connecting the two boards.

A basic power reset by unplugging the washer for a few minutes may temporarily clear the code, but it will return if the underlying communication fault is still present. F60 reflects a real hardware issue with the wiring or boards, not a software glitch, so a reset alone is not a repair. The harness and connectors should be inspected and tested before assuming the problem is resolved.

Repair costs vary depending on what component has failed. If only the wire harness needs replacement, parts costs are generally in the range of $20 to $80. A replacement User Interface board typically costs between $80 and $200 in parts, while a new Central Control Unit can range from $100 to $300 or more. Adding professional labor will increase the total, usually by $100 to $200 depending on your location and the technician's rates.

Many cases of F60 are caused by a loose or disconnected wire harness connector, which a careful DIYer can address by locating and reseating the connectors between the UI board and the CCU. If the harness has a broken wire or a board has failed, repairs become more involved and may require a multimeter for continuity testing and sourcing a replacement part. If you are not comfortable working with appliance wiring, a technician is the safer choice.

You should not attempt to run the washer while F60 is active. The error indicates that the control boards cannot communicate, meaning the CCU cannot properly monitor or respond to user commands during a cycle. Running the machine in this state could lead to unpredictable behavior. Resolve the fault before attempting to use the washer.