Kenmore Washer Error Code PS

PS stands for pressure sensor error on a Kenmore washer. It means the control board is not receiving a valid signal from the pressure switch assembly, which is the component responsible for monitoring the water level in the tub. The washer will stop operation until the fault is resolved to prevent overfilling or running with insufficient water.

It is not recommended to continue running the washer while the PS error is active. The pressure sensor controls water fill levels, so operating without a reliable sensor signal could lead to overfilling and potential water damage or running the motor with insufficient water. The washer typically stops itself when this code appears as a protective measure.

Repair costs depend on what is causing the fault. If loose connectors are the issue, there is no parts cost. Replacing a pressure switch typically costs between $20 and $60 for the part, plus labor if a technician is hired. A full diagnostic and repair performed by a professional technician could run anywhere from $100 to $250 or more depending on the specific component involved and local labor rates.

Yes, some causes of the PS error are DIY-friendly. Checking and reseating the wiring connectors at the pressure switch and main PCB requires no special tools and is a good starting point. Inspecting and clearing the air hose or air dome is also manageable without professional help. Replacing the pressure switch itself is a moderate repair that many technicians and experienced DIYers can complete.

A reset may temporarily clear the PS error, but it will return if the underlying fault is not repaired. To reset, unplug the washer for a few minutes and then restore power. If the pressure switch, wiring, or air hose has an actual fault, the code will reappear once the washer attempts to fill and the sensor issue is detected again.