KitchenAid Dishwasher Error Code Anti-Bacterial/Heavy + China Gentle + Quick Rinse

This button combination activates a diagnostic mode that displays a drain pump current sense error. It means the control board has detected that the electrical current drawn by the drain pump motor is outside the expected range. This can be caused by a jammed impeller, a failing pump motor, damaged wiring, or a faulty control board. The dishwasher may stop mid-cycle or fail to drain as a result.

It is not recommended to continue running the dishwasher while this error is present. A drain pump current sense error can indicate an electrical fault or a blocked pump, and operating the appliance in this condition could worsen the damage to the pump motor or control board. Address the underlying cause before resuming normal use.

A power reset, such as unplugging the unit or tripping the circuit breaker for a few minutes, may temporarily clear the error from the display. However, if the underlying cause is not corrected, the fault will return as soon as the dishwasher attempts to run the drain pump again. A reset alone is not a fix and should only be used as part of the diagnostic process.

Some causes, such as debris clogging the drain pump impeller, can be addressed without special tools by cleaning the filter and pump area accessible under the lower spray arm. However, diagnosing a failing motor or damaged wiring harness requires a multimeter and some comfort working with electrical components. If the control board is the source of the fault, replacement is best handled by a qualified technician.

Repair costs vary depending on the faulty component. Replacing a drain pump motor typically runs between $150 and $350 including parts and labor. A control board replacement can range from $200 to $500 or more. If the issue is only a wiring repair or a simple clog, the cost may be significantly lower, particularly if you handle the cleaning yourself.