KitchenAid Dishwasher Error Code Anti-Bacterial/Heavy + Normal Wash + China Gentle + Quick Wash + Quick Rinse

This combination of lit buttons is KitchenAid's way of displaying a fill sensing error. It means the dishwasher attempted to fill with water but the control board did not receive confirmation that the tub reached the correct water level within the expected time. The dishwasher stops the cycle to protect the pump and heating element from running dry.

No, you should not attempt to run the dishwasher while this error is active. The fill sensing error indicates water is not entering the tub properly, and operating the pump and heating element without adequate water can cause serious damage to both components. Resolve the underlying cause before running another cycle.

A reset may clear the error display temporarily, but the code will return as soon as the dishwasher attempts to fill again if the underlying problem has not been corrected. To reset, cancel the current cycle and disconnect power to the unit for a few minutes. Use the reset only as a step to confirm the repair was successful after addressing the actual cause of the fill sensing fault.

Start by confirming the water shutoff valve under the sink is fully open and the supply hose is not kinked. Next, clean the float assembly at the bottom of the tub to make sure it moves freely. If those checks pass, inspect the water inlet valve for a clogged screen or a failed solenoid coil, and check all wiring connections between the valve, float switch, and control board for damage or corrosion.

Repair costs vary depending on the root cause. If the fix is simply opening a shutoff valve or cleaning the float switch, there is no parts cost involved. A replacement water inlet valve typically costs in the range of $25 to $75 for the part, with professional labor adding $80 to $150 or more depending on your area. A control board replacement is the most expensive scenario, often ranging from $150 to $350 for the part alone.