KitchenAid Dishwasher Error Code China Gentle + Quick Rinse

This button combination indicates a main control board memory corruption fault. It is displayed as part of the dishwasher's built-in diagnostic system rather than being a cycle selection. The control board's onboard memory has encountered a read or write error that prevents normal operation. This fault can appear after a power event or due to internal board component failure.

A power reset by cutting power at the breaker for a few minutes can clear the fault if the memory corruption was caused by a temporary power interruption or surge. If the error reappears after the reset, the corruption is likely persistent and the control board will need to be replaced. Repeated resets without addressing the root cause will not resolve an underlying board failure.

If the fault clears with a simple power reset, there is no parts cost involved. If the main control board requires replacement, parts alone typically range from $100 to $300 depending on the specific model, with professional labor adding an additional $75 to $200. Total repair costs can range from $175 to $500 or more when using a professional technician.

You can attempt a power reset first by shutting off the dishwasher's circuit breaker for several minutes and then restoring power. If the fault was caused by a transient voltage event, this may clear the error. However, if the code returns after resetting, the main control board likely requires replacement, which is a more involved repair that requires sourcing the correct board for your model.

Operating the dishwasher with an active memory corruption fault is not recommended. A corrupted control board can cause unpredictable cycle behavior, failure to stop filling, or incomplete cycles that may leave dishes improperly cleaned or the unit in an unintended state. It is best to avoid use until the fault is diagnosed and resolved.