LG Air Conditioner Error Code E241

E241 means the condenser outlet temperature sensor has come loose from its mounting holder on the refrigerant pipe. The sensor, a thermistor that monitors refrigerant temperature exiting the condenser, is no longer in proper contact with the pipe. The unit triggers this fault because it cannot obtain reliable temperature readings. The fix is often as simple as reattaching the sensor to its holder clip on the pipe.

It is not recommended to continue operating the unit while E241 is active. Without accurate condenser outlet temperature data, the system cannot properly protect the compressor or regulate refrigerant flow, which could lead to further component damage. Address the sensor attachment issue before resuming normal operation.

If the sensor only needs to be reattached to its holder, there may be little to no parts cost involved, though a service call to diagnose and access the unit could range from around $75 to $150 or more depending on your location. If the sensor holder or the thermistor sensor itself needs replacement, parts costs are generally modest, but total repair costs including labor could range from $100 to $300 or more. Getting a diagnostic estimate from a qualified technician is the best way to determine the actual cost for your specific situation.

In many cases, yes. The first step is to locate the COND OUT sensor on the condenser outlet pipe and check whether it has slipped out of its holder bracket. Re-inserting the sensor and snapping the holder back into place is a straightforward mechanical fix that does not require special tools. If the holder is broken or the sensor wiring is damaged, those components will need to be replaced, which may require a technician.

A simple reset will not permanently clear E241 if the sensor is still detached from its holder. The error will return as soon as the control board detects that the sensor readings are still missing or erratic. The underlying mechanical issue, the sensor being out of its holder, must be corrected first. Once the sensor is properly reattached and the unit reads stable temperatures, the error should clear.