mypros+
Error code reference

LG Refrigerator Error Code E 22

Fridge fan error (RSG5B* model display).

LG codesLG refrigerator codes

Fridge fan error (RSG5B* model display).

First step from the service manual

Check voltage between MAIN PCB CN74 GRAY and GREEN; should be 7V~12V.

The complete diagnostic procedure includes additional test steps, resistance specifications, wiring diagram references, and component test points.

MyPros+ Max

Get the full diagnostic procedure for E 22.

  • Step-by-step tests with expected resistance, voltage, and continuity values
  • Wiring diagram references and connector pinouts from the OEM service manual
  • Verified part numbers when replacement is required
Get the full procedure

$29/month · Cancel anytime · Or $9.95 3-day pass

What E 22 means on a LG refrigerator

The E 22 error code on LG RSG5B-series refrigerators indicates a fridge (fresh food compartment) fan fault. The control system monitors the fan motor's operation continuously, and when the MAIN PCB detects that the fan is not performing within expected parameters, it triggers this error and displays E 22 on the unit. The fan in question circulates cold air from the evaporator throughout the fresh food section, so a failure here directly compromises temperature maintenance in that compartment.

The primary diagnostic entry point for this fault is measuring the supply voltage at connector CN74 on the MAIN PCB, checking between the GRAY and GREEN wires. This voltage should read between 7V and 12V under normal operating conditions. A reading outside this range points toward a board-level supply problem rather than the fan motor itself. If the voltage is correct at CN74, the fault is more likely in the fan motor, its wiring harness, or a mechanical obstruction preventing the motor from spinning freely.

Common failure scenarios include a seized or worn fan motor, ice buildup around the fan blade causing it to stall, damaged wiring between the PCB and the motor, or a failed MAIN PCB that is not delivering the proper drive voltage. Because this fan is essential for even cooling across the fresh food section, ignoring E 22 can lead to warm temperatures, food spoilage, and potential secondary issues such as excessive compressor run time.

Source: manufacturer service documentation.

Common causes of E 22

  1. 01

    Failed fridge fan motor

    Part replacement

    The fan motor itself may have burned out or seized due to wear. If supply voltage at CN74 is confirmed within the 7V to 12V range but the fan does not spin, the motor is the likely culprit.

  2. 02

    Ice buildup blocking the fan blade

    Wiring / connection

    Ice accumulation around the evaporator area can physically jam the fan blade, causing the motor to stall and triggering the error. Inspect for frost or ice obstructing the fan during diagnosis.

  3. 03

    Incorrect or absent voltage at MAIN PCB CN74

    Part replacement

    If the voltage measured between the GRAY and GREEN wires at CN74 falls outside the 7V to 12V specification, the MAIN PCB is not providing correct power to the fan circuit, indicating a board-level fault.

  4. 04

    Damaged or open wiring harness

    Wiring / connection

    Wiring between the MAIN PCB connector CN74 and the fan motor can fray, corrode, or develop open circuits. Inspect the harness for visible damage, pinched wires, or loose connector pins.

  5. 05

    Faulty MAIN PCB

    Part replacement

    If voltage at CN74 is incorrect and no wiring faults are found, the MAIN PCB itself may have failed internal components affecting the fan drive output. Board replacement or repair would be required.

See the test procedure for each cause

Frequently asked questions about E 22

What does E 22 mean on a LG refrigerator?
E 22 on an LG RSG5B-series refrigerator indicates a fridge fan error, meaning the fresh food compartment fan has stopped operating correctly or is not receiving proper voltage from the MAIN PCB. The control board monitors fan performance and triggers this code when a fault is detected. The fan is responsible for circulating cold air throughout the fridge section, so this error can directly affect cooling performance.
How do I fix the E 22 error on my LG refrigerator?
Start by checking the voltage between the GRAY and GREEN wires at connector CN74 on the MAIN PCB. The reading should be between 7V and 12V. If voltage is correct, inspect the fan motor and its wiring harness for damage or ice obstruction. Depending on what you find, the fix may involve defrosting the unit, replacing the fan motor, repairing wiring, or replacing the MAIN PCB.
Is it safe to keep using my refrigerator when it shows E 22?
Continuing to use the refrigerator with an active E 22 error is not recommended. Without the fridge fan operating, cold air will not circulate properly through the fresh food section, leading to inconsistent or elevated temperatures. Food safety can be compromised fairly quickly if temperatures rise above safe storage levels, so the fault should be addressed promptly.
Will resetting the refrigerator clear the E 22 error?
A power reset may temporarily clear the E 22 display, but the code will return if the underlying fault is still present. Resetting does not repair a failed fan motor, fix damaged wiring, or correct a board voltage problem. A proper diagnostic check is needed to resolve the root cause before the error will stay cleared.
How much does it cost to repair an E 22 error on an LG refrigerator?
Repair costs depend on the failed component. A replacement fridge fan motor typically ranges from around $30 to $90 for the part alone, while a MAIN PCB replacement can range from $100 to $250 or more. Adding labor charges from a technician, total repair costs generally fall between $100 and $400 depending on the diagnosis. A wiring repair or simple defrost to clear an ice blockage would be on the lower end of that range.

Related LG refrigerator codes

All LG refrigerator codes
View all 485 LG refrigerator codes

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass