LG Washer Error Code 2044

Error code 2044 means the washer has detected that the drive motor work windings are open circuit, meaning the resistance measured across the motor winding cable pairs is outside the acceptable specification. This points to an internal motor coil failure or a wiring fault between the motor and control board. The washer cannot operate the drum until this fault is resolved.

Resetting the washer by unplugging it for a few minutes will clear the displayed code temporarily, but the fault will return as soon as the control board re-tests the motor windings. Because 2044 reflects a measured electrical failure in the motor or its wiring, it will not resolve on its own without an actual repair.

If the motor requires replacement, parts costs typically range from roughly $150 to $350 depending on the specific model, with professional labor adding $100 to $200 or more. If the fault turns out to be a damaged wiring harness or connector rather than the motor itself, repair costs can be considerably lower. Getting a diagnosis before ordering parts is advisable to confirm which component has actually failed.

A knowledgeable DIYer can perform the diagnostic step by disconnecting the motor harness and using a multimeter to measure resistance across each specified winding cable pair. If wiring and connectors are intact and the motor reads open, the motor itself will need to be replaced. Motor replacement on LG direct drive washers requires disassembling the rear of the machine and is moderately difficult.

The washer will not complete a wash cycle with this fault active, so in practice it is already inoperable. Attempting to force operation with a damaged motor winding is not recommended, as an open winding can cause additional electrical stress on the control board. The machine should remain out of service until the motor or wiring fault is corrected.