LG Washer Error Code BR

The BR code on an LG washer stands for brake resistor error. It indicates a fault detected in the brake resistor circuit, which is part of the motor drive system responsible for safely dissipating energy when the drum decelerates. This error causes the washer to stop operating to protect the electronics. LG directs customers to contact an authorized LG service center for diagnosis and repair.

Unplugging the washer for a few minutes and restarting may temporarily clear the BR code if the fault was caused by a transient condition such as overheating. However, if the brake resistor, wiring, or inverter board has a hardware failure, the error will return as soon as the machine attempts to run a spin cycle. A reset is not a substitute for proper diagnosis.

Repair costs vary depending on which component has failed. If only the wiring harness needs repair, costs are typically lower, often in the range of $100 to $200 including labor. If the inverter board or brake resistor assembly requires replacement, costs can range from $200 to $450 or more depending on parts pricing and local labor rates. A service technician can provide an accurate estimate after diagnosis.

The BR error involves the inverter drive circuit, which operates at potentially dangerous voltage levels, including stored charge in DC bus capacitors even after the machine is unplugged. Because of this, LG recommends contacting an authorized service center rather than attempting a self-repair. A qualified technician has the tools and training to safely test the brake resistor, wiring, and inverter board.

No, you should not continue running the washer when the BR code is active. The error indicates a fault in the motor braking circuit, and operating the machine in this condition could cause further damage to the drive electronics or create an unsafe situation. Keep the washer off and contact LG service to have it inspected.