LG Washer Error Code DR

DR stands for drainage error on LG washers. It means the machine attempted to drain the water from the tub but could not complete the process within the 10-minute limit set by the control board. The washer stops the cycle automatically to prevent damage. Common causes include a kinked drain hose, a clogged filter, or a faulty drain pump motor.

No, you should not continue running the washer while the DR error is active. The machine will have standing water in the tub that has not drained, and running additional cycles without resolving the underlying problem can strain the motor and other components. Address the drainage issue before resuming normal use.

Repair costs depend on the cause. Cleaning a clogged drain hose or filter costs nothing beyond your time. If the drain pump motor needs to be replaced, parts alone typically range from $20 to $80, and adding professional labor can bring the total to $150 to $300 or more depending on your location. A control board replacement, if needed, will generally cost more than a pump motor.

Start by checking the drain hose for kinks, folds, or blockages and make sure it is not inserted too deeply into the standpipe. Next, locate and clean the drain pump filter, which often collects lint and debris. If the hose and filter are clear, inspect the drain pump motor and its wiring connector for damage or loose connections. If the pump motor has failed, it will need to be replaced.

A reset may temporarily clear the code and allow the washer to attempt another cycle, but the error will return if the root cause has not been fixed. To reset, unplug the machine for a few minutes and then plug it back in. The DR code will reappear as soon as the washer tries to drain again if the blockage or component failure is still present.