LG Washer Error Code E-36

E-36 means the washer detected that the door was opened during the weight sensor mode phase of the cycle. This phase requires a fully closed and latched door to accurately measure the load. The machine halts the cycle and displays this code to prevent the cycle from continuing with incorrect sensor data. You will need to close the door, cancel the current mode, and restart the cycle from the beginning.

Canceling the current cycle and restarting is the recommended reset procedure for E-36 and will clear the error if the door was simply opened accidentally. However, if the underlying cause is a faulty door latch or door switch, the error will return during the next cycle at the same phase. In that case, the hardware issue must be addressed before the fault clears reliably.

If the error was caused by accidentally opening the door, there is no repair cost at all. If the door latch assembly needs replacement, parts typically range from $15 to $60 depending on the specific model, with professional labor adding $75 to $150 or more. A door switch replacement is generally in a similar parts cost range and is often a straightforward repair for someone comfortable with basic disassembly.

Start by firmly closing the door until you hear the latch click, then cancel the active cycle and restart it from the beginning. If the error returns without the door being opened, inspect the door latch assembly and door switch for wear or damage. A faulty latch or switch may need to be replaced to resolve the fault permanently.

E-36 itself is not a safety hazard in the same way as an electrical or motor fault, but the machine will not complete the cycle correctly while this error is active. If the door latch is faulty and failing to hold the door closed during operation, continued use without repair could eventually allow water to escape. It is best to diagnose and correct the root cause before running full cycles.