LG Washer Error Code E-44

The E-44 code on an LG washer indicates an Easy/PH sensor dry-up error. This means the sensor designed to monitor water contact or cycle conditions has detected that it is dry or not properly in contact with water or laundry. The machine stops the cycle to prevent operating under abnormal conditions. The first step is to add laundry to the drum and restart the cycle.

The washer will typically halt the cycle when E-44 appears, so it is not operating in a way that poses an immediate safety risk. However, you should not repeatedly attempt to run cycles while ignoring the fault, as the underlying cause could indicate a sensor or water supply issue. Resolve the error before continuing regular use.

If the fix is as simple as adding laundry and restarting, there is no cost involved. If the Easy/PH sensor needs to be cleaned or its wiring repaired, costs can vary depending on whether you use a technician or handle it yourself. A sensor replacement plus labor from a professional repair service typically falls in the range of 80 to 200 dollars, depending on your location and the specific parts required.

Start by placing an appropriate load of laundry in the drum and restarting the cycle, as the sensor requires contact with material to function correctly. If the error returns, check that the water supply valves are fully open and the inlet hoses are not kinked. Inspect the sensor for mineral or detergent buildup and clean it if needed. If none of these steps resolve the issue, the sensor or its wiring connection may need professional inspection.

A basic reset may temporarily clear the error code, but if the root cause is not addressed, the fault will return when the same conditions occur again. The recommended approach is to add a load of laundry and restart rather than simply resetting the machine. If the sensor is faulty or fouled, a reset alone will not fix the underlying problem.