LG Washer Error Code EB

The EB code on an LG washer stands for Motor Triac Short Error. It means the control board is receiving more than 300 tachometer signals per second from the motor circuit, which indicates a short circuit in the triac component that controls motor power. This fault causes the washer to stop operating to prevent additional damage to the motor or electronics.

No, it is not safe to continue operating the washer while the EB error is active. A shorted triac can allow uncontrolled electrical current to flow through the motor circuit, which risks overheating the motor, damaging additional components on the control board, or causing an electrical hazard. The machine should remain off until the fault is diagnosed and repaired.

Replacing an individual triac component requires desoldering the failed part from the control board and soldering in a replacement, which demands electronics repair skills and proper tools. Most technicians and experienced DIYers choose to replace the entire control board rather than attempt component-level repair. If you are not comfortable working with circuit boards and AC-powered appliances, professional service is the safer option.

Turning the power switch off is the first recommended step and may clear a temporary fault. However, if the triac has actually failed in a shorted state, the EB error will return as soon as the machine attempts to run again. A recurring EB code after a power reset almost always means a hardware component needs to be replaced.

Repair costs depend on which component has failed. A replacement motor control board or main control board typically ranges from around 80 to 250 dollars for the part alone, plus labor costs that vary by region. If the drive motor itself also needs replacement, total repair costs could range from 200 to 500 dollars or more. Getting a diagnosis first helps avoid replacing parts that are still functional.