LG Washer Error Code EE

The EE code on an LG washer indicates a fault in the direct drive motor system, specifically involving erroneous signals from the motor hall sensor or a broken connection somewhere between the motor and the main control board. Possible causes include loose motor connector terminals, a disconnected IPM terminal on the PBA, a displaced DD motor cover, a disconnected PCB housing terminal, a faulty PBA, or a failed DD motor. The washer will stop operating until the fault is resolved.

No, you should not attempt to run the washer while the EE code is active. The code means the control board cannot reliably communicate with the drive motor, and running the machine in this state could cause further damage to the motor or the main PBA. Unplug the unit and diagnose the fault before resuming use.

If the fix is simply reseating a loose terminal or connector, there may be no parts cost at all, though a service call fee typically ranges from around 75 to 150 dollars. If the DD motor needs to be replaced, parts and labor can range from roughly 200 to 450 dollars depending on the model and service provider. A failed main PBA replacement tends to fall in a similar cost range of 150 to 400 dollars including labor.

Start by unplugging the washer and inspecting all terminal connections at the DD motor connector, the IPM terminal on the main PBA, and the PCB housing terminal. Reseat any loose connectors and check for corrosion or bent pins. Also confirm that the DD motor cover is properly positioned. If connections are all secure and the code returns, the DD motor or main PBA may need to be tested further and potentially replaced.

A reset may temporarily clear the code from the display, but if the underlying connection fault or component failure is still present, the EE code will return when the washer tries to operate the motor again. A reset is not a fix and should not substitute for a proper inspection of the motor terminals, connectors, and related components.