LG Washer Error Code Eg

The Eg code on an LG washer means the EEPROM input/output test has passed and no error was detected. EEPROM is the memory chip on the control board that stores the machine's settings and calibration data. This is a diagnostic status code, not a fault, so it indicates the memory system is working correctly. It most commonly appears when the washer is in or has recently been in a service diagnostic mode.

Yes, the Eg code represents a passed diagnostic test, meaning no fault has been found in the EEPROM memory system. It does not indicate a hazardous condition or component failure. If the washer is otherwise behaving normally, it is safe to continue using it. Exit diagnostic mode first by pressing Power or unplugging the machine briefly.

Because Eg is a passing diagnostic status and not a fault code, there is usually no repair cost involved. If the code is accompanied by other issues pointing to a failing main control board, replacement control boards for LG washers typically range from $150 to $350 in parts, with professional labor adding another $100 to $200 depending on your location and service provider.

Because Eg indicates a passed test rather than a failure, no repair is typically required. You can try exiting diagnostic mode by pressing the Power button or unplugging the washer for about one minute, then plugging it back in. If the code disappears and the washer runs normally, no further action is needed. If it continues to appear during regular cycles, inspect the control board and its wiring connections.

In most cases, yes. Unplugging the washer for about 60 seconds and plugging it back in should exit any diagnostic mode and clear the Eg display. If the code returns on its own during a normal wash cycle, it may be worth checking whether a button combination is being accidentally triggered, or whether the control board needs closer inspection.