LG Washer Error Code VS

The VS code on an LG washer indicates a vibration sensor communication error. This means the control board attempted to communicate with the vibration sensor and failed, either due to a sensor register setup error, a wiring problem, or the sensor being disconnected or removed. The washer will not complete spin cycles while this fault is active.

You should not continue using the washer while the VS error is active. The vibration sensor is part of the system that detects dangerous drum imbalance during spin cycles. Operating the machine without functional sensor feedback removes a key protection against mechanical damage that could worsen the repair and potentially create a safety hazard.

Repair costs vary depending on the root cause. A simple wiring harness reconnection done by a technician may cost between $75 and $150 for a service call. Replacing the vibration sensor itself typically ranges from $100 to $250 including parts and labor. If the main control board is at fault, costs can range from $200 to $450 or more depending on parts availability and labor rates in your area.

Some cases of the VS error can be resolved without professional help by checking that the vibration sensor's wiring harness is securely connected at both ends. If connectors appear intact and undamaged, the sensor itself or the wiring harness may need to be replaced, which is a more involved repair. A technician with experience in LG washers is recommended if basic wiring checks do not resolve the fault.

A power cycle reset, performed by unplugging the washer for a few minutes and restarting it, can clear a VS error caused by a transient sensor initialization failure. However, if the underlying cause is a physical wiring problem, a disconnected sensor, or a failed sensor component, the code will return once the machine attempts to communicate with the sensor again.