Skip to main content
Error code reference
Magic Chef Washer Error Codes
29 error codes documented with diagnostic procedures.
Have your model number? Get codes specific to your unit.
d13Coin 2 error-the Coin 2 sensor is detected as blocked for 8 seconds.d16Generation 2 debit card reader error-no communication from installed debit card reader in…d5Coin 1 error-the Coin 1 sensor is detected as blocked for 8 seconds.d9Low voltage detection error-incoming voltage detected below 90VAC for 8 seconds.E1Fails to reach preset water level after injecting water for about 16 minutes.E2Open lid alarmE3Washing machine imbalance detected after three correction attempts.E4Draining fails to finish after draining for 4 minutes.E5Overflow alarm triggered by water inlet hose issue.E6Door failed to properly lock or unlock.F01CCU error-communication error within the Central Control Unit; the pump drive in CCU…F03Accelerometer failure-the X, Y, and Z limits are outside of the normal range.F04Accelerometer failure-the X, Y, and Z limits are outside of the normal range (same as…F11MCU error-Motor Control Unit has a failure, possibly a repeating under or overvoltage…F20No water detected entering washer-first level of pressure switch not reached within 6…F21Long drain-drain time exceeds 8 minutes without reaching reset level in pressure switch.F22Door lock error-washer made several attempts to lock the door without success; if entire…F24Temperature sensor error-water temperature sensor value is out of range (23°F to 217°F /…F25Tachometer error-MCU is unable to properly detect motor speed, washer shuts down.F26Door switch error-the door switch circuit is open for 5 seconds while the door is locked.F27Overflow condition-the overflow contact on the pressure switch is closed for more than 60…F28Communication failure between CCU and MCU.F29Door unlock error-the door is unable to unlock after 6 tries.F31Overheating of motor-the heat sink exceeds 212°F (100°C); procedure can repeat up to 4…F33Pump disconnected-the electrical connection between the pump and the CCU is lost.F34Load detected in washer during washer cleanout cycle.F70Communication failure between CCU and UI (User Interface).F73UI failure-communication error within the User Interface.F74UI failure-communication error within the User Interface (same as F73).
Get the full diagnostic procedure for any code
Step-by-step tests, expected values, wiring diagram references, and verified part numbers.
Get Started $9.95 3-day pass$29/month for all brands and Max diagnostics, with 70 Max messages a day. Plus applicable tax.