Maytag Dryer Error Code d

Error code "d" on a Maytag dryer means the UI microprocessor cannot read or verify the EEPROM, which is the onboard memory chip that stores cycle and pricing data. As a result, cycle selection and price display functions are disabled. The dryer will not operate normally until this code is manually cleared by a technician.

When error code "d" is active, the dryer disables cycle selection and pricing display, meaning it will not operate normally. Because the dryer is effectively in a non-operational state for its standard functions, there is no immediate safety hazard from the code itself. However, you should not attempt to bypass the error and force operation without resolving the underlying EEPROM communication issue.

If the error requires only a manual diagnostic code clearing with no parts replacement, costs would typically be limited to a service call fee, generally in the range of $75 to $150. If the control board needs to be replaced due to a failed EEPROM or damaged circuitry, total repair costs including parts and labor typically fall in the range of $150 to $400 depending on the specific board and technician rates in your area.

The first step is to manually clear the diagnostic code using the proper procedure for your model, which may resolve the error if it was caused by a temporary power interruption. If the code returns after clearing, the EEPROM chip or the control board itself may need to be replaced, which is a more involved repair. Technicians with control board experience can handle this, but it is not a typical DIY repair for most homeowners.

Simply unplugging the dryer and restoring power is unlikely to clear error code "d" because this code requires a manual diagnostic clearing procedure rather than a standard power reset. If the code was caused by a one-time data corruption event, manually clearing it through the proper procedure may resolve the issue. If the EEPROM or control board is physically damaged, the code will return after clearing.