Monogram Oven Error Code ERR

ERR on a Monogram oven means a temperature was entered that falls outside the allowable cooking range of 170°F to 550°F. The control board rejects any setpoint below or above those limits and displays ERR instead of starting a cook cycle. This is a protective input validation response and is not a sign of a hardware fault in most cases. Clearing the entry and setting a temperature within the accepted range will typically resolve it immediately.

Yes, the ERR code on a Monogram oven is a user input alert, not a safety fault or mechanical failure. The oven is simply refusing to start a cook cycle because the entered temperature is out of range. Once a valid temperature is entered, the oven should operate normally and safely.

If the ERR code is caused by a simple input mistake, there is no repair cost at all. If a faulty touchpad is to blame, replacement touchpad assemblies typically range from $50 to $200 or more depending on the model, plus labor if a technician is hired. Control board replacement, if needed, generally runs higher, often in the $150 to $400 range for parts alone.

Press the Cancel or Clear button to exit the current entry, then re-enter a cooking temperature between 170°F and 550°F. Confirm the number on the display before pressing Start. If the error continues to appear even when entering a valid temperature, the touchpad or control board may require inspection.

In most cases, pressing the Cancel button is sufficient to clear ERR without needing a full reset. If the code persists, you can power cycle the oven by switching off the circuit breaker for 30 seconds and restoring power. However, a power reset will not fix the underlying issue if a faulty touchpad is causing unintended inputs.