mypros+
Error code reference

Sharp Dishwasher Error Code E9

Some buttons have been pressed for over 30 seconds continuously.

Avg. service call
$285
National average. Trip fee plus diagnostic plus labor. Before parts.
MyPros+ 3-day pass
$9.95
Same diagnostic steps, on your phone. Start now.
You keep in your pocket
~$275
Even before you buy the part.
Skip the service call. Fix it yourself.
Full procedure unlocks instantly.
Get Started

What the E9 error code actually means

Your Sharp dishwasher detected that one of the buttons on the control panel has been held down or stuck in place for more than 30 seconds. This usually means a button is physically jammed, something is pressing against the panel, or there is moisture or debris interfering with the controls. The dishwasher stops normal operation until the problem is resolved.

Diagnostic procedure

The full E9 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Check the control panel assembly
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock E9 procedure $9.95

Or subscribe: $29/month for unlimited access to all codes plus Max AI diagnostics.

Most common causes of E9

Ranked by how often they cause this code
  1. 1Stuck or jammed control panel button
  2. 2Moisture or liquid intrusion under the membrane
  3. 3Foreign object pressing against the panel
  4. 4Damaged or misaligned ribbon cable
  5. 5Failed main control board

Most DIYers save hundreds by diagnosing before ordering parts.

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

Questions people ask about E9

What does E9 mean on a Sharp dishwasher?
The E9 code means the dishwasher detected that one or more control panel buttons have been continuously pressed or held active for more than 30 seconds. The control board treats this as a fault condition and halts normal operation. It is typically caused by a stuck button, moisture under the keypad, or something physically pressing against the control panel.
Will resetting my Sharp dishwasher clear the E9 error?
A power reset by disconnecting the dishwasher from power for a few minutes may temporarily clear the E9 code, but the error will return if the underlying cause is not corrected. If a button is physically stuck or the membrane is damaged, the fault condition will be detected again as soon as the unit powers back on.
How much does it cost to repair a Sharp dishwasher E9 error?
Repair costs depend on the failed component. A replacement membrane keypad or control panel assembly typically falls in the range of $50 to $150 for parts, while a main control board can range from $100 to $250 or more. Adding professional labor costs, total repair estimates generally run between $100 and $400 depending on the diagnosis and your location.
How do I fix the E9 error on my Sharp dishwasher?
Start by inspecting the control panel for any button that feels stuck, is visibly damaged, or does not spring back properly when pressed. Remove any objects near or leaning against the panel. If moisture is suspected, allow the panel to dry completely. If the problem persists after a reset, the membrane keypad or control board may need to be replaced.
Is it safe to use my Sharp dishwasher while the E9 error is displayed?
It is not recommended to continue running the dishwasher with an active E9 error. The control board has detected an abnormal input condition and has interrupted normal operation for this reason. Running the unit with a stuck or malfunctioning control input could lead to unintended cycle behavior or further component stress.

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass