Speed Queen Washer Error Code dor

The dor code is a door open indicator, meaning the washer does not detect a confirmed closed door signal when a cycle is attempted. Speed Queen washers require the door to be securely latched before the control will allow a cycle to run. The code can appear because the door is genuinely open, or because a faulty door switch or wiring issue is preventing the closed signal from reaching the control board.

No, the washer will not operate while the dor code is active, which is intentional. Running a washer with an unconfirmed door closure could result in water leaks or spinning with the door unsecured. Resolve the door switch or latch issue before attempting to use the machine.

If the fix is a door latch switch, parts typically range from around $15 to $60 depending on the model, and the repair is often manageable as a DIY task. If a wiring harness section needs replacement, costs vary more widely. A professional repair visit, including labor, generally runs in the range of $100 to $250 total depending on the technician and parts required.

Start by firmly closing the door and making sure nothing is caught in the door seal or latch. If the error persists with the door closed, inspect the door latch and strike for visible wear or damage. Check the wiring connector at the door switch for looseness or corrosion, and use a multimeter to test the switch for continuity when latched. If the switch fails the continuity test, replacing it is the most likely fix.

A reset may temporarily clear the display, but the dor code will return immediately when you attempt to start a cycle if the underlying problem has not been fixed. The control checks the door switch status at the start of every cycle, so the code will reappear until the door latch, switch, or wiring issue is corrected.