Whirlpool Dryer Error Code Blocked coin 1

This error indicates a problem with the first coin drop circuit on a Whirlpool commercial dryer. It means either a physical blockage is present in the coin chute or acceptor, or the coin recognition and UI control circuit has failed. While the fault is active, coin recognition and the customer display are disabled, making the machine unusable for pay-per-use operation.

A simple power reset is unlikely to permanently clear this error if an underlying physical blockage or component failure is present. The fault is tied to a persistent condition in the coin drop circuit, so it will typically return after a reset unless the root cause has been resolved. The blockage or failed component must be addressed before the error clears reliably.

Repair costs vary depending on the root cause. Clearing a physical blockage is typically a low-cost service call, mostly covering labor. Replacing a coin drop assembly or UI control board will add parts costs, and total repair expenses can range from around 50 dollars for a simple clearing to several hundred dollars if control board or coin acceptor replacement is needed, plus labor rates in your area.

Start by inspecting the coin chute and coin drop acceptor for any jammed coins, foreign objects, or debris and clear any blockages found. If no physical obstruction is present, check the wiring and connectors between the coin acceptor and the control board for damage or corrosion. If the wiring is intact and the error persists, the coin drop assembly or UI control board may need to be replaced by a qualified technician.

The dryer disables coin recognition and the customer display while this fault is active, so normal coin-operated use is not possible in this state. There is no indication that this error presents a safety hazard such as a fire or electrical risk, but the machine should be taken out of service for customers until a technician can diagnose and repair the coin drop circuit.